Quarry Mud and Safety
Posted: Mon Jul 06, 2026 8:51 pm
Hello all, I'm new around here and wanted to ask a few questions about staying safe when sinking into quarry mud. I have tried sinking in mud quite a few times now, and I really enjoy it! The mud I have found and sunk into has mainly consisted of lake recesses and a few streams. I think the type of mud has mostly been a red clay sand mix. (Tons of sticks and grainy sand) My only problem is that all the places I find feel super public, and being close to the road stresses me out. I've started to get tired of scratching up my legs, so I wanted to try something creamy and sticky with nothing in it that gets past my waist.
So, I scouted a few quarries and after checking out a few, most were inaccessible from what I could see, except for one. This quarry has an amazing spot that I think should work really well, I think that area might not be in use too. But since I am new to quarries I have some concerns. As annoying as it was, I couldn't find a stick to gauge the depth because I was worried about being seen. (I didn't have the best parking spot, and I think they might still have been open). So that's issue one. Secondly, for the very brief amount of time I stepped in with my shoes I stood there for a second to catch my breath then tried to climb the brim nearby to get out and that stuff had some insane suction, and that was just the surface level stuff. I wanted to know if that could be a possible problem when trying to sink in it.
Let me describe the pit too to give a little more details too because I don't have any photos (whoops). I wasn't able to get a stick to gauge the depth because there weren't too many nearby in the more private section of the quarry. So instead, I used stones at the top of the berm to test consistency and thickness. I threw one into the thicker part, and the rock stayed at the surface, while the other one made a plop, splashed, and went under. There is a massive amount of silt (I think that's what it is, not too sure about terminology yet. It was white and looked sandy but was soft like clay when stepping on dryer stuff.) to the right of the pit, and it seems like the pit is a collection of runoff from that giant mound. There is 4 sections to the pit. First, is the dried crust stuff at the front of it. Second is a thicker, clay-looking section (the part where I mentioned my shoes). Third is a more watery section that seemed more liquidly. (I knew this from the stones). Fourth Is a small puddle of water, Its not very deep and from what I could tell and it was pretty dirty but I'm not too picky. I do have concerns about if it would be safe to even enter that section of the mud to clean up though. I have ideas for an alternative cleanup I saw online; more on that in a second.
All in all, I am very excited to try out this mud, but I want to be as safe as possible. I don't sink with clothes on besides a suit or underwear, so I am not concerned about boot suction. I will have a rope, but I am worried about where I could tie it, from what I remember I don't think I saw anything, although I wasn't looking for that at the time. (It has knots tied on it so I should be able to grip it) Also, I would really like proper tips on how to get unstuck from the quarry mud because I have heard the suction is crazy. I think I want to do another scout at some point this week so I can get pictures, test the depth with a stick, and to send here to help with context. (Probably Tomorrow or Wednesday, so I will reply here with photos if I do go.)
My goal is to try and get out there this weekend at night, as it might rain and it will be closed. Also real quick too, would rain even be a good idea? But if I can't get out there for a second site visit, I might hold off. As for that alternative cleaning method, I found this website that talks about a way to wash off without getting in water, and I want to try it. Has anyone seen it or tried this method, and do you know if it's effective?
(Link: https://www.spotlesssploshing.com/post/ ... n-clean-up)
I am bring everything listed in the mud kit on the website and I will probably bring more washing water and towels, as I have heard and seen that this stuff is pretty sticky.
Thank you for any replies, I really appreciate them! I hope to get to know ya'll better!
So, I scouted a few quarries and after checking out a few, most were inaccessible from what I could see, except for one. This quarry has an amazing spot that I think should work really well, I think that area might not be in use too. But since I am new to quarries I have some concerns. As annoying as it was, I couldn't find a stick to gauge the depth because I was worried about being seen. (I didn't have the best parking spot, and I think they might still have been open). So that's issue one. Secondly, for the very brief amount of time I stepped in with my shoes I stood there for a second to catch my breath then tried to climb the brim nearby to get out and that stuff had some insane suction, and that was just the surface level stuff. I wanted to know if that could be a possible problem when trying to sink in it.
Let me describe the pit too to give a little more details too because I don't have any photos (whoops). I wasn't able to get a stick to gauge the depth because there weren't too many nearby in the more private section of the quarry. So instead, I used stones at the top of the berm to test consistency and thickness. I threw one into the thicker part, and the rock stayed at the surface, while the other one made a plop, splashed, and went under. There is a massive amount of silt (I think that's what it is, not too sure about terminology yet. It was white and looked sandy but was soft like clay when stepping on dryer stuff.) to the right of the pit, and it seems like the pit is a collection of runoff from that giant mound. There is 4 sections to the pit. First, is the dried crust stuff at the front of it. Second is a thicker, clay-looking section (the part where I mentioned my shoes). Third is a more watery section that seemed more liquidly. (I knew this from the stones). Fourth Is a small puddle of water, Its not very deep and from what I could tell and it was pretty dirty but I'm not too picky. I do have concerns about if it would be safe to even enter that section of the mud to clean up though. I have ideas for an alternative cleanup I saw online; more on that in a second.
All in all, I am very excited to try out this mud, but I want to be as safe as possible. I don't sink with clothes on besides a suit or underwear, so I am not concerned about boot suction. I will have a rope, but I am worried about where I could tie it, from what I remember I don't think I saw anything, although I wasn't looking for that at the time. (It has knots tied on it so I should be able to grip it) Also, I would really like proper tips on how to get unstuck from the quarry mud because I have heard the suction is crazy. I think I want to do another scout at some point this week so I can get pictures, test the depth with a stick, and to send here to help with context. (Probably Tomorrow or Wednesday, so I will reply here with photos if I do go.)
My goal is to try and get out there this weekend at night, as it might rain and it will be closed. Also real quick too, would rain even be a good idea? But if I can't get out there for a second site visit, I might hold off. As for that alternative cleaning method, I found this website that talks about a way to wash off without getting in water, and I want to try it. Has anyone seen it or tried this method, and do you know if it's effective?
(Link: https://www.spotlesssploshing.com/post/ ... n-clean-up)
I am bring everything listed in the mud kit on the website and I will probably bring more washing water and towels, as I have heard and seen that this stuff is pretty sticky.
Thank you for any replies, I really appreciate them! I hope to get to know ya'll better!